rain [linuxoid@conference.linuxoid.in] - 2025/02/25 10:15:40		http://isida.dsy.name

U-Boot 1.1.3 (Apr 14 2017 - 09:10:36)

Board: Ralink APSoC 128 MB
relocate_code Pointer at: 87fbc000
*****%%%%%%%%%%%%%%%%%%%%%%���ͅ����HW
***************************
find flash: GD25Q128C c8, device id 40��R
*** Warning - bad CRC, using default environment

============================================
Ralink UBoot Version: 4.3.S.0
--------------------------------------------
ASIC 7628_MP (Port5<->None)
DRAM component: 1024 Mbits DDR, width 16
DRAM bus: 16 bit
Total memory: 128 MBytes
Flash component: SPI Flash
Date:Apr 14 &�������09:10:36
icache: sets:512========�����4, linesz:32 ,total:65536
dcache: sets:256, ways:4, linesz:32 ,total:32768

 ###�$����CPU freq = 575 MHZ ####
 estimate memory size =128 Mbytes
RESET MT7628 PHY!!!!!!

Hit Ctrl+B to stop autoboot:  0
## Booting image at bc040000 ...
   Image Name:   MIPS OpenWrt Linux-3.10.14
   Image Type:   MIPS Linux Multi-File Image (lzma compressed)
   Data Size:    1310728 Bytes =  1.3 MB
   Load Address: 80000000
   Entry Point:  80000000
   Contents:
   Verifying Checksum ... OK
   Uncompressing Multi-File Image ... OK
No initrd
## Transferring control to Linux (at address 80000000) ...
## Giving linux memsize in MB, 128

MT7628 # help                   
?       - alias for 'help'
bootm   - boot application image from memory
cp      - memory copy                       
erase   - erase SPI FLASH memory
go      - start application at address 'addr'
help    - print online help                  
loadb   - load binary file over serial line (kermit mode)
md      - memory display                                 
mdio   - Ralink PHY register R/W command !!
mm      - memory modify (auto-incrementing)
mtest   - simple RAM test                  
mtkswitch   - Ralink switch register command
mtkswitch_port_status - Ralink switch port status
nm      - memory modify (constant address)       
printenv- print environment variables     
reset   - Perform RESET of the CPU   
rf      - read/write rf register  
saveenv - save environment variables to persistent storage
setenv  - set environment variables                       
spi     - spi command              
tftpboot- boot image via network using TFTP protocol
version - print monitor version  
MT7628 # printenv              
bootargs=console=ttyS1,115200 root=31:02 rootfstype=jffs2 init=/sbin/init mtdparts=raspi:256k(u-boot),64k(u-boot-env),2240k(rootfs),1408k(uImage),64k(mib0),64k(ART)
bootcmd=bootm 0xbc040000                                                                                                                                            
bootdelay=1             
baudrate=115200
ethaddr="00:AA:BB:CC:DD:10"
ipaddr=192.168.1.1         
serverip=192.168.1.10
stdin=serial         
stdout=serial
stderr=serial
             
Environment size: 328/4092 bytes
MT7628 # version                        

U-Boot 1.1.3 (Apr 14 2017 - 09:10:36)

MT7628 # spi id
device id: c8 40 18 ff 60